Dial Backup And Leased Line Restore Setup - Multitech MultiModem II MT5600BA-V92 User Manual

Dial Backup and Leased Line Restore Setup

1. Connect a telephone cable to the LINE jack of an MT5600BA-V92 modem set up for leased
line operation. Connect the other end of the cable to a standard dialup line jack.
2. Turn on the modem.
3. Starting at the STATUS LCD, press the following buttons on the front panel:
, . The ENTER NUMBER LCD appears.
4. Press the
number.
5. Press the
To backspace or to cancel an entry, press
Note:
6. The number can be up to 30 characters in length. Repeat steps 4 and 5 until the number is
entered, and then press the Enter button to store it. The DIAL BACKUP # STORED LCD
appears.
7. Press the Enter button again to go to the DIAL BACKUP NUMBER LCD.
Steps 8 through 15 are optional.
Note:
8. To change the default restore time, press
then press
9. Press the
10. Press the
11. Repeat steps 9 and 10 until you have entered a value between 10 and 255, or 0 to disable
dial backup, and then press the Enter button to store it. The TIME STORED LCD appears.
12. Press the Enter button to return to the TIME TO RESTORE (S15) LCD.
13. To change the default dial backup time, press
LCD, then press
14. Repeat steps 9 and 10 until you have entered a value between 0 and 255, and then press the
Enter button to store it. The TIME STORED LCD appears.
15. Press the Enter button again to return to the DIAL BACKUP TIME (S17) LCD.
16. Dial backup and leased line restore setup is complete.
Notes:
•
Registers S15 and S17 can also be changed using the Sr=n AT command. See the AT
Command Reference Guide on the CD that was shipped with your modem.
•
The dial backup number can be displayed only 16 characters at a time. To see
characters 17–30, press the
go to the next LCD, press the
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
or button several times to select the first digit in the dial backup telephone
button to go to the next digit in the number.
, . The ENTER TIME IN MINUTES LCD appears.
or button several times to select the first digit in the number.
button to go to the next digit in the number.
, . The ENTER TIME IN MINUTES LCD appears.
button. To go to the previous LCD, press the
button.
Chapter 4 – Leased Line Operation
several times.
to go to the TIME TO RESTORE (S15) LCD,
to go to the DIAL BACKUP TIME (S17)
, , , , ,
button. To
31