Table of Contents
Advertisement
Command:
+FRH
Description:
Defined Values:
Reporting Current or Selected Values:
Reporting Supported Range of Parameter Values:
Result Codes:
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer's Guide
Receive Data with HDLC Framing
This command causes the modem to receive frames using HDLC protocol
and the modulation defined below. An ERROR response code results if this
command is issued while the modem is on-hook.
<mod> Decimal number corresponding to the selected modulation mode and
data rates shown in Table 6-2.
Command: +FRH?
Response: +FRH: <mod>
Example: +FRH: 98 For V.17 9600 bps.
Command: +FRH?
Response: +FRH?
Example: +FRH: 98 For V.17 9600 bps.
CONNECT Reported for either of two conditions:
1. When the selected carrier is detected with an HDLC flag.
2. If the DTE sends another +FTH=<MOD> command after sending the result
code indicating frame reception is complete.
+FCERROR Reported if a different carrier is detected and FAR=0.
NO CARRIER Reported if loss of carrier is detected.
OK Reported for either of two conditions:
1. If a frame was received correctly.
2. If the DTE sends any character other than XON or XOFF while the modem
is in the configured flow control.
ERROR Reported if a frame was received in error.
Chapter 6 – Fax Class 1 and Class 1.0 Commands
93
Advertisement
Table of Contents
