Multitech SocketModem MT5600SMI-32 Developer's Manual page 42

Command: T
Description:
Result Code:
Command: P
Description:
Result Code:
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer's Guide
Chapter 5 – AT Commands, S-Registers, and Result Codes
of silence before the expiration of the call abort timer (S7), the
modem will terminate the call attempt with a NO ANSWER message.
If busy detection is enabled, the modem may terminate the call with
the BUSY result code. If answer tone arrives during execution of this
parameter, the modem handshakes.
& Wait for credit card dialing tone before continuing with the dial string.
If the tone is not detected within the time specified by S7 (US
models) or S6 (W-class models), the modem will abort the rest of the
sequence, return on-hook, and generate an error message.
, Dial pause: the modem will pause for a time specified by S8 before
dialing the digits following ",".
; Return to command state. Added to the end of a dial string, this
causes the modem to return to the command state after it processes
the portion of the dial string preceding the ";". This allows the user to
issue additional AT commands while remaining off-hook. The
additional AT commands may be placed in the original command line
following the ";" and/or may be entered on subsequent command
lines. The modem will enter call progress only after an additional dial
command is issued without the ";" terminator. Use "H" to abort the
dial in progress, and go back on-hook.
^ Toggles calling tone enable/disable: applicable to current dial
attempt only.
( ) Ignored: may be used to format the dial string.
- Ignored: may be used to format the dial string.
<space> Ignored: may be used to format the dial string.
<i> Invalid character: will be ignored.
> If enabled by country specific parameter, the modem will generate a
grounding pulse on the EARTH relay output.
Set Tone Dial Default
Forces DTMF dialing until the next P dial modifier or P command is
received. The modem will set an S-Parameter bit to indicate that all
subsequent dialing should be conducted in tone mode. The DP command
will override this command. Clears S14 bit 5.
This command may not be permitted in some countries. (See P.)
OK
Set Pulse Dial Default
Forces pulse dialing until the next T dial modifier or T command is
received. Sets S14 bit 5.
As soon as a dial command is executed which explicitly specifies the
dialing mode for that particular call (e.g., ATDT...), this command is
overridden so that all future dialing will be tone dialed. (See T command.)
This command may not be permitted in some countries.
OK
42