Before You Begin - Razor RipStik Electric Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches, or dents that may have occurred during shipping. Because the RipStik Electric was
99% assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 8 hours for charge (see page 6 for charging information).
Charger
(Note: Charger design may
vary from one shown)
2.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Remote
Remote Holster
1.
Urethane Wheel
360° Inclined Caster
Charger Port
On/Off Switch
Battery
Hub Motor
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
RIPSTIK ELECTRIC. The RipStik
Electric has been built to certain
Razor design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame and all other
parts. Certain aftermarket prod-
ucts may not be compatible and
will void the warranty.
Note: RipStik Electric must be
moving at least 3 mph (5 km/h)
while holding the lever on the
remote in the "GO" position for
motor to engage.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• RipStik Electric
• Remote
• Two (2) AAA Batteries
• Charger
• Owner's Manual