Assembly And Set-Up; Installing Remote Batteries; Remote Pairing Confirmation; Pairing The Remote - Razor RipStik Electric Owner's Manual

ASSEMBLY AND SET -UP

Installing Remote Batteries

Tool Required: Phillips screwdriver
1
Loosen Phillip screw on battery
cover and remove cover.

Remote Pairing Confirmation

Note: Your remote should have been paired with your RipStik Electric at the factory.
1
Turn the power switch on the
remote to the ON position.

Pairing the Remote

1
Turn the power switch on the
remote to the OFF position.
2
Install two (2) AAA batteries.
2
Press power button on the
product to the ON position.
If the power button on the product
is solid red, then the product has
been successfully paired at the
factory and no further steps are
needed.
2
Turn product over. Open the
pairing button cover located
underneath the rear platform.
3
Re-attach battery cover
and securely tighten in place
with screw.
3
If power button on product
is flashing, leave power button
on the product in the ON position.
See Pairing the Remote section
below for pairing instructions.
4