Table of Contents
Advertisement
REPAIR AND MAINTENANCE
Rear Wheel/Hub Motor Replacement
Tools Required: Phillips Screwdriver and Two (2) 13 mm Wrenches
A
B
A
B
1
Turn product over. Loosen the four (4) Phillip screws on the rear platform
cover and remove cover.
2
Disconnect the motor connector from the control module.
3
Using a 13 mm wrench, loosen
the outside locknut (11-6). Use a 13
mm wrench to prevent the inside
nut (11-3) from turning.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
B
A
2X
2X
ACTUAL SIZE
4
Loosen the three (3) Phillips screws that attach the motor housing to the
frame. Remove rear wheel.
Install replacement wheel/hub motor by reversing steps 1-4.
9
Note: Rear wheel/hub motor
hardware sequence
11-3 11-6
11-4
11-5
11-1 11-2
Left Side
11-1 Phillips Screws (x3)
11-2 Motor Housing
Right Side
11-3 Nut
11-4 Spring Washer (x2)
11-5 Flat Washer
Frame
11-6 Locknut
Hide quick links:
Advertisement
Table of Contents
