Table of Contents
Advertisement
ASSEMBLY
Tool:
Open Wrench 12,13 mm 1PC
1. Front and Rear Stabilizer Installation
1.1 Front Stabilizer Installation.
Lift up the front part of Main Frame (E-1) and then align the Front Stabilizer (I-1) onto the front
curve of the Main Frame. From the bottom, insert 2 Carriage Bolts (N-1) through the holes. Next
place two Flat Washers (N-3), two Spring Washers (N-2) and two Domed Nuts (N-6) on top of the
Carriage Bolts (N-1). Hold the Front Stabilizer (I-1) to the Main Frame (E-1) and use the Open
Wrench 12, 13mm to tighten the Domed Nuts (N-6).
SEE NEXT PAGE for hardware pictures.
Pro Tip : You can place a solid piece of styrofoam underneath the Main Frame (E-1) to make it
easier to install the stabilizers.
1.2 Rear Stabilizer Installation.
Lift up the rear of the Main Frame (E-1) and then align the Rear Stabilizer (J-1) onto the rear
curve of the Main Frame (E-1). From the bottom, insert 2 Carriage Bolts (N-1) through the holes.
Next place two Flat Washers (N-3), two Spring Washers (N-2) and two Domed Nuts (N-6) on top
of the Carriage Bolts (N-1). Hold the Rear Stabilizer (I-1) to the Main Frame (E-1) and use the
Open Wrench 12, 13mm to tighten the Domed Nuts (N-6).
9
Advertisement
Table of Contents
