Auto Changeover - Robertshaw 9801i2 User Manual

OVERRIDE CURRENT SETTINGS
Setting a hold when the operating mode is Auto Changeover.
When the selected mode is Auto Changeover, setting a hold means that two setpoints (one for heat and one for cool) have to be
chosen. The distance between the heating and cooling setpoints cannot be smaller than the deadband. (For more information
about deadband, see COMFORT SETTINGS on page 18.)
NOTE: There is a letter A next to the
The settings are the same for Auto Changeover as they are for just Heat or Cool (see previous page), except both a heat and cool
hold temperature must be selected.
Hold Temperature
Heat: 65 Cool: 80
50 60 70 80 90
Cancel Next
Set At 77 Until 12:20PM
68
°F
A
.9
9:15 AM
Outside 42 50%RH
Menu
Resume
page 2 of 2
on the main screen. This shows that Auto Changeover is active.
NOTE: The or above the arrows are the heat and cool setpoints respectively. The unlabeled arrow
is the current room temperature.
Press the or button until the desired Heat temperature is displayed. Select Next. Press the
button until the desired Cool temperature is displayed. Select Next. The Select Override Type screen
appears. Follow the Select Override Type steps from the previous page to complete the hold setting.
10
or