Sony BDV-N9100W Operating Instructions Manual page 50

Calibrating the
Appropriate Speaker
Settings Automatically
[Auto Calibration]
D.C.A.C. DX (Digital Cinema Auto
Calibration DX) brings you the ideal sound
experience by automatically adjusting the
setting of the speakers' distance, location,
and acoustic.
]k' m'l'_
• The system outputs a loud test sound when
[Auto Calibration] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• Before [Auto Calibration], make sure that all the
speakers are connected to the main unit and
surround amplifier.
I _' m 'l'l
1
Press HOME.
The home menu appears on the TV
screen,
2
Press */* to select _ [Setup].
3
Press )/) to select [Audio
Settings], then press _.
4
Press )/) to select [Auto
Calibration], then press _.
The [Select speaker layout.] display
appears.
5 Press )/) to select setting
according to your speakers
placement, then press _.
• [Standard]: The surround speakers
are installed in the rear position.
• [All Front]: All speakers are installed
in the front position.
The confirmation display for [Auto
Calibration] appears.
6
7
8
Connect the calibration mic to
the A.CAL MIC jack on the rear
panel.
Set up the calibration mic at ear level
using a tripod, etc. (not supplied). The
calibration mic should aim the TV
screen. The front of each speaker
should face the calibration mic, and
there should be no obstruction between
the speakers and the calibration mic.
Press t/,t to select [OK].
To cancel, select [Cancel].
Press _.
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
9
• Be[k>re [AutoCalibration], make sure that
the surround amplifier isturned on and you
have installed the surround amplifier in an
appropriate
location to ensure wireless
comlection with it.
• While [Auto Calibration] is in progress,do
not
operate the system.
Confirm the result of [Auto
Calibration].
The distance and level for each speaker
appear on the TV screen.
I _' m 'l'l
II measurement lails, follow the message
then retry [Auto Calibralion].
I
0Press )/) to select [OK] or
[Cancel], then press _.
• The measurement is OK.
Disconnect the calibration mic, then
select [OK]. The result is
implemented.
• The measurement is not OK.
Follow the message, then select [OK]
to retry.
50 Us