Part2 For The Operator; Other Basic Sales Entries; Additional Information For Basic Sales Entry; Error Warning - Sharp XE-A303 Instruction Manual

Part2 FOR THE OPERATOR

OTHER BASIC SALES ENTRIES

1

Additional Information for BASIC SALES ENTRY

Clerk assignment
Prior to any item entries, clerks must enter their clerk codes into the register. However, the code entry may not
be necessary when the same clerk handles the consecutive transactions. The clerk codes 1 to 4 can be
assigned by default.
I Sign-on (in REG, MGR,
To display the signed-on clerk code
Clerk code
Receipt ON/OFF function
When you use the printer to issue receipts, you can disable receipt printing in the REG mode to save paper
using the receipt ON/OFF function. To disable receipt printing, press the
key toggles the receipt printing status ON and OFF.
The register will print reports regardless of the receipt state, so the paper roll must be installed.
To issue a receipt when receipt ON/OFF function is set to OFF:
If your customer wants a receipt after you finalized a transaction with the receipt ON/OFF function being OFF
R
status, press the
receipt will be issued in a summary receipt.
Copy receipt
You can print a copy receipt by pressing the
To realize this function, you must enable the function. Please refer to page 71 (Job code 63).
Power Save Mode
The register will enter into power save mode when no entries are performed based on the pre-programmed time
limit (by default, 30 minutes).
When the register goes to the power save mode, all display lights will turn off except the decimal point at the
leftmost position. The register will return to the normal operation mode when any key is pressed or a mode is
changed with the mode key. Please note when the register is recovered by a key entry, its key entry is invalid.
After the recovery, start the key entry from the beginning.
2

Error Warning

In the following examples, your register will go into an error state accompanied with a warning beep and a
corresponding error message. Clear the error state by pressing the
Please refer to the error message table on page 98.
• Enter over a 32-digit number (entry limit overflow): Cancel the entry and re-enter the correct number.
• An error in key operation: Clear the error and continue operation.
• An entry beyond a programmed amount entry limit: Check to see if the entered amount is correct. If it is
correct, it can be rung up in the MGR mode. Contact your manager.
• An including-tax subtotal exceeds eight digits: Delete the subtotal by pressing the
A X Y c
, , ,
36
mode)
L
key. This will produce a receipt. However, if more than 30 items were entered, the
R
b
or key to finalize the transaction.
I Sign-off (in REG, MGR,
L
R
key when the receipt ON/OFF function is in the "ON" status.
l
key and take the proper action.
mode)
L
key in the OP X/Z position. This
l
key and press the