Installation; Before You Begin; Single Station Installation - ATEN Master View CS-9134 User Manual

Installation

Before you Begin

1. Make sure that the power to each of the devices you will be
connecting up has been turned off. You must unplug the
power cords of any computers that have the Keyboard Power
On function.
2. Make sure that all devices on the installation are properly
grounded.

Single Station Installation

In a Single Stage installation, there are no additional Master View's cascaded
down from the first unit. To set up a single stage installation do the following:
1. Plug your keyboard, mouse, and monitor into the unit's Console Ports.
2. Use KVM cable sets (as described in the Cables section on p. 3), to
connect any available CS-88A CPU Port to the Keyboard, Video and
Mouse ports of the computer you are installing.
3. If you choose to use external power, plug the power adapter cable into the
Master View's Power Jack, then plug the adapter into an AC power source.
Note: The switch is designed for non-powered operation in a single stage
installation by taking its power from the computers via the KVM
cables. If a computer, only supplies 3.3V of power for the keyboard
and mouse instead of 5V (as in the case of Notebooks, for
example), the unit will not receive enough power, and you will need
to use the external power adapter.
4. Turn on the power to the computers.
Note: If you choose to use external power, the Master View unit must be
plugged in and receiving power prior to turning on the power to the
computers.
CS-9134 / CS-9138 User Manual
2005-12-21
7