ENGLISH
Loosen the two nuts (c). Adjust the two adjusting nuts (d) to
make sure the splitter is approximately 1/8" (3 mm) above the
blade tips. Tighten the two nuts (c).
To adjust the alignment of the splitter
The splitter must be precisely IN LINE with the saw blade.
Loosen the two nuts (c) and align the splitter with the saw
blade. Once aligned, hold the splitter. To prevent personal
Injury, always unplug the saw from power source before
making any adjustments.
Installing the anti-kickback pawls (FIG. F1 and F2)
NOTE: The Splitter (3) needs to be in working position to
install the anti-kickback pawl assembly.
1. Raise the blade to the highest position and set bevel
at 0°. Make sure the bevel is locked tight.
2. Place the anti-kickback pawl assembly over the
"keyhole" Slot (1) (Fig. D2) on the Splitter (3). Depress
the plastic cap on the lock pin in the direction shown
on Fig. F1. Rotate the lever downwards, and make
sure the lock pin fully engages the slot (1).
3. Release the plastic cap to secure assembly. Make
sure there is no movement in the anti-kickback pawl
assembly.
To uninstall the anti-kickback pawl assembly, depress the
plastic cap on the lock pin to release it. Rotate the lever
downwards, pull and remove the assembly from the splitter.
Plastic cap
8
d
c
D3
F1
Lever
2. Place the blade guard assembly down on the splitter.
Depress the lock button.
3. Slide the blade guard assembly backwards and
push it downwards with a little force so that the lock
pin engages fully into the slot (3).
4. Release the lock button to secure. See Fig. G2
Lock Button
Installing the extension table and extension rail
Insert the extension pieces into the holes of the table (See
Fig. H1) and screw down the knob. (See Fig. H2)
F2
G1
G2
H1