Assemble The Stand’s Legs - Stanley STST1825 Original Instruction

ENGLISH
Clearly identify the parts shown in Fig. A1 and A2,
including the fittings. Group these parts together and
ensure that you have the correct quantity of all the
pieces shown.
1 x 4 pieces
2 x 2 pieces
3 x 2 pieces
4 x 2 pieces
5 x 2 pieces
Bolt
5
3
1
2
2. Assemble the stand's legs
Step 1
Select the following parts:
2 x Part 1
1 x Part 3
1 x Part 5
Lay the parts together as shown in Fig. B1, B2, and
B3. This is best done by simply laying the parts
loosely together on the floor. Once you are satisfied
that you have the parts correctly laid together, start
the fitting process.
Align the holes and secure with the bolts (a) as shown
in Fig. B1.
DO NOT fully tighten the bolts, nuts and washers at
this point. Finger tight is sufficient.
Step 2
Repeat Step 1 so that there are two frames assembled.
6
Washer Nut
1
4
2
1
5
4
3
1
A2
A1
Step 3
Select the following parts:
2 x Part 2
2 x Part 4
These will form the crosspieces between the
previously assembled frames. Lay the parts flat on
the floor. Connect the longer Part (2) and fix it to the
frame in the center of the uprights. Note that Part
2 should be positioned as shown in Fig. B4. Connect
Part 4 (top cross support) to the top of the frame. Note
that Part 4 should be positioned as shown in Fig. B4.
B2
4
1
2
a
B1
B3
5
3
B4