Section 2: To The Owner; Section 3: Contents Of Carton - MTD OEM-190-627 Operator's Manual

SECTION 2: TO THE OWNER

Model 627 42-inch two-stage snow thrower is designed for use on 600-series lawn tractors manufactured in
1996 or later ONLY. It will NOT fit nor operate properly or safely on ANY other tractor. It will NOT fit on any
FastAttach™ compatible tractor.
NOTE: If your 600-series lawn tractor was manufactured prior to 1996, model 627 snow thrower attachment can be
mounted on the tractor with special instructions and minor modifications to the tractor. Phone our Customer Support
Department as instructed on page 2 for details.
NOTE: References to LEFT and RIGHT indicate the left and right sides of the tractor when facing forward in the
operator's position. Reference to the FRONT indicates the grille end; to the REAR the drawbar end.

SECTION 3: CONTENTS OF CARTON

Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents
are listed below and shown in Figure 3. Part numbers are shown in parentheses.
• One Auger Housing Assembly
• One Undercarriage Assembly with
Upper V-belt (754-0449) & Lower V-belt (754-0330)
• One Support Carriage Assembly
• One Chute Directional Control with Tilt Lever
• One Lift Handle Assembly with Cable
• One Upper Chute Crank Rod
• Two Self-adhesive Reflectors (730-3000)
• Three Cable Ties (725-0157)
• One Extension Spring (732-0626)
with Upper V-belt & Lower V-belt
Lift Handle Assembly
With Cable
Self-adhesive Extension
Reflectors Spring
Undercarriage Assembly
Belleville Washers,
Cable
Ties 1¼ Cotter Pins
• Two Spare Shear Bolts (710-0890A)
& Hex Lock Nuts (712-0429)
• One Flat Washer (736-3019)
• One Hairpin Clip (714-0145)
• Two Hex Screws (710-0376)
• Two Belleville Washers (736-0242)
• Two Lock Washers (736-0119)
• Two Hex Nuts (712-3010)
• Two 1¼-inch Cotter Pins (714-0470)
• One ¾-inch Cotter Pin (714-0507)
Chute Directional Control
with Tilt Lever
Support Carriage Assembly
Hex Screws,
Lock Washers
and Hex Nuts
Figure 3
5
Upper Chute Crank Rod
Auger Housing Assembly
Flat Washer ¾-inch Spare Shear Bolts
& Hairpin Clip Cotter Pin & Hex Lock Nuts