Machine Specification - Revo R322 Original Instructions Manual

MACHINE SPECIFICATION

REVO - R322 DRILL
Machine Height
Machine Width
Machine Depth
Stroke
Machine Weight
Rated Motor Power
Voltage
Rated Current
IP Rating
Spindle Speed - load
Spindle Speed - n
0
No. of speeds
FWD/REV
Power Cord Length
Insulation Class
Annular Cutter Capacity
Standard Cutting Depth
Twist Drill Capacity
Tapping Capacity
Countersink
Chuck Type
Spindle Fitting
Magnet Dimensions
Magnet Power
Magnetic Adhesion
Minimum Plate Thickness 10mm (minimum recommended)
Sound Pressure Level
Sound Power Level
SPL at Operators Head
Hand-arm Vibration
The vibration measurement was made under standard conditions in accordance with the
requirements of BS EN 60129-1:2009.
The actual vibration level during use will depend on the workpiece stability/rigidity and the
condition of the cutter used. These factors may increase the vibration experienced by the
operator, each individual application of the tool should be assessed for the effect of these
application variable factors, before exposure.
.
305mm (slide in down position)
120mm (without handles)
275mm
156mm
12.0kg (tool and detachable parts)
850W
110V / 230V AC
7.8A / 3.7A
IP20
390 /min (depends on cutter size and feed rate)
690 /min
Single Speed
No
2.5m
CLASS I
Ø32mm
25mm (50mm with optional long Arbor)
Ø13mm
N/A
Yes
3/4" Weldon Shank Arbor or 13mm Chuck
1/2" x 20 UN
160mm x 85mm
50W
1000kg (measured on 25mm thick plate)
88 dBA
101 dBA
92 dBA (1.55m high x 1m distance) Uncertainty 3 dBA
2
Less than 2.5 m/s
3
Uncertainty 3 dBA
Uncertainty 3 dBA
Uncertainty 1.5m/s
R322 DRILL - W18XC473 - Revised 231111
2
.