Setting And Testing; Mounting Of Cutters Into The Arbor - Revo R322 Original Instructions Manual

SETTING AND TESTING - USING THE SAFETY STRAP
A cam buckle type safety strap is provided.
The power tool has a strap slot to allow the
safety strap to be attached securely.
Always ensure the strap is correctly fitted and
the machine is secure BEFORE starting the
motor unit.
The safety strap is used to reduce the risk of
injury in the case of a power supply or
electrical malfunction.
A correctly fitted safety strap will hold the
power tool if the electro-magnet looses its
magnetic adhesion.
If the strap becomes damaged or lost, it must
be replaced BEFORE using the power tool.
DO NOT use the safety strap as an
alternative clamping method, the
electro-magnet should have good magnetic
adhesion at all times whilst using this power
tool.
MOUNTING CUTTERS INTO THE ARBOR
The holder for the cutting tool is known as the
arbor. The arbor is designed to accept
Powerbor 3/4" Weldon shank annular cutters.
The Powerbor annular cutters normally have
two flats disposed at 90°to each other.
To mount the cutter.
First ensure the ejector pin is in place.
Align the flats with the two fixing screws.
Push the cutter up into the arbor until it stops.
Tighten the two fixing screws onto the cutter
flats with the hex keys supplied.
14
STRAP
SLOT
CAM
BUCKLE
FEED
THROUGH
THIS WAY
R322 DRILL - W18XC473 - Revised 231111
PRESS
HERE