Drill Unit Spindle Control - Revo R322 Original Instructions Manual

OPERATION - SPINDLE - START / STOP
The drill unit or "motor" is controlled by a twin push button
switch (H) at the top of the control panel. MOTOR
The green button is ON the red button is OFF.
The green button is below with the surrounding bezel.
The red button is raised above the surrounding bezel.
H
This is to prevent inadvertent operation of the drill unit.
The motor will not operate unless the magnet is switched
ON first.
BEFORE starting the motor, the security of the magnet
should be physically checked, if any movement is possible
this should be rectified BEFORE using the drill.
The motor control has an under-voltage relay, if the power
is interrupted the motor will stop and will not restart when
the power is resumed until the motor control is operated
again.
18
R322 DRILL - W18XC473 - Revised 231111