Unpacking And Assembly; Setting-Up Or Fixing Tool In A Stable Position; Connection To Power Supply - Revo R322 Original Instructions Manual

UNPACKING AND ASSEMBLY

The REVO R322 DRILL comes in a rugged blow moulded carrying case before first use:-
1. Remove the machine from the carrying case. (Note:- 12.0kg weight)
2. Fit the three screw in handles to the pinion shaft.
Fit the safety guard as shown in the instructions, see "Using the safety guard"
3.
Fit the arbor, as detailed in the instructions under "Fitting the Drill Chuck / Arbor"
4.
SETTING UP THE TOOL
Before using the tool please ensure you have read the sections on the intended and
prohibited of use of the machine.
The machine should only be used for hole drilling whilst attached to the work piece by the
electro-magnetic base.
This machine is intended for use at any angle, but only if the electro-magnet is in full
working order and has sufficient hold on the work piece material.
The safety strap should be attached in case of power failure or machine malfunction.
The safety strap should NOT be used as an alternative to the magnet for clamping
purposes.
Always ensure the strap is correctly fitted and the machine is secure BEFORE starting
CONNECTION TO THE POWER SUPPLY
Connection to the power supply is by 2.5m cable and plug.
For the 230V machine this is by a 3 pin plug with earth connection.
For the 110V machine this is via a CEE type 2pin+earth plug.
The BS1363 plug version is fused, the European Schuko type plug is not fused.
This tool is CLASS I insulation and MUST be earthed, any power socket the tool is
connected to must have an earth.
Before the power cord is connected the magnet switch should be in the OFF position.
The power cord assembly is a custom terminated one, replacement should only be car-
ried out by a qualified electrician. Only use the replacement parts listed below.
Power cord part numbers:-
For connection information, should the power cord need to be replaced, please refer to
the wiring diagram in this manual or the connection label inside the rear panel of the
power tool.
230V ~ BS Plug
230V ~ EU Plug
110V ~ 2P+E
11
18X503
18X503/EU (Shuko / VDE)
18Y181
R322 DRILL - W18XC473 - Revised 231111