Table of Contents
Advertisement
Supplied Hardware
S
4 rubber feet. For stand-alone installation.
S
1 rackmount bracket, long. For half-rack (single unit)
installations.
S
1 rackmount bracket, short. For half-rack (single) or
dual-mount installations.
S
2 straddle brackets. For dual-mount or fixed installations.
S
1
12 bracket screws,
/
brackets to the chassis.
S
4 rackmount screws, 1 in. (2.5 cm). For mounting the
unit in a rack.
S
4 plastic washers. For use with the supplied rackmount
screws.
S
4 wood screws, 1/2 in. (1.25 cm). For fixed installations.
Bracket Screw
Rackmount Screw
Rackmount Installation
The SCM262 can be mounted as a single unit or
dual-mounted with either another SCM262 or another Shure
half-rack unit such as the SCM268 or DFR11EQ.
1. Attach the rackmount brackets using one of the following
methods:
Single unit (half-rack) installation: Attach the short and
long rackmount brackets to the SCM262 with eight (8) of
the supplied bracket screws.
Dual-mounted installation:
a)
Connect the two units together side-by-side using
two (2) straddle brackets. The brackets should
straddle the recessed edges on on the top and
bottom of each chassis. Fasten them using eight (8)
bracket screws.
NOTE: Be sure to use both straddle brackets—one
on the top and one on the bottom.
b)
Attach the short rackmount brackets to the outsides
of the combined units with eight (8) of the bracket
screws.
INSTALLATION
-in. (6 mm). For securing the
4
Wood Screw
2. After attaching the brackets, mount the unit in an
equipment rack using the supplied rackmount screws and
plastic washers.
Stand-Alone Installation
Adhere the four (4) supplied rubber feet to the bottom of
the unit at each corner. This will keep it from sliding and protect
the table surface.
Fixed Installation
To permanently affix the SCM262 above or below a table,
shelf, or counter top, use the following steps:
1. Fasten the straddle brackets to the recessed edges of the
chassis using four (4) bracket screws.
Top mount: Fasten the straddle brackets to on the
bottom of the unit
Hanging mount: Fasten the straddle brackets to the top
of the unit.
2. Fasten the straddle brackets to the surface using the four
(4) supplied wood screws.
English –
5
TOP MOUNT
HANGING MOUNT
Advertisement
Table of Contents
