1. Manuals
  2. Brands
  3. AMX Manuals
  4. Remote Control
  5. MIO R-4
  6. Instruction manual

Checking Connection Status; Checking The Master Ip Address; Checking The Gateway Ip Address; Checking The Gateway Eui Address - AMX MIO-R4 Instruction Manual

Hide thumbs Also See for MIO-R4:
Table of Contents

Advertisement

System Settings
Status
Connected to System
Master IP
Icsp Mode
Device Number
Gateway IP
Gateway EUI Address
Device EUI
Extended PANID
Network Scan
ZigBee Diagnostic

Checking Connection Status

1.
Select Protected Settings in the Setup Menu.
2.
Select System Settings in the Protected Settings Menu. If the round button at the top right of the first page is green, the
system is connected.
3.
Select the Back button until you are out of the Setup Menu.

Checking the Master IP Address

1.
Select Protected Settings in the Setup Menu.
2.
Select System Settings in the Protected Settings Menu. The master IP is indicated on the first page.
3.
Select the Back button until you are out of the Setup Menu.

Checking the Gateway IP Address

1.
Select Protected Settings in the Setup Menu.
2.
Select System Settings in the Protected Settings Menu. The gateway IP is indicated on the second page.
3.
Select the Back button until you are out of the Setup Menu.

Checking the Gateway EUI Address

1.
Select Protected Settings in the Setup menu.
2.
Select System Settings in the Protected Settings Menu.
3.
Select the device's down arrow to navigate to the second page. The Gateway EUI address is indicated on the second page.
4.
Select the Back button until you are out of the Setup Menu.

Checking the Extended PAN ID

1.
Select Protected Settings in the Setup Menu.
2.
Select System Settings in the Protected Settings Menu.
3.
Select the device's down arrow to navigate to the second page. The Extended PAN ID is indicated at the bottom of the page,
above the Network Scan and ZigBee Statistics buttons.
4.
Select the Back button until you are out of the Setup Menu.

Changing the Device Number

1.
Select Protected Settings in the Setup Menu.
2.
Select System Settings in the Protected Settings Menu.
3.
The Device Number button at the bottom of the first page lists the current NetLinx Device Number for the unit.
4.
To change the device number, press the Device Number button to open the Device Number page.
5.
Enter the new device number with the device keypad.
To move the cursor back one number at a time, press the Back button.

To clear the entire device number field, press the Clear button.

To return to the System Settings page without saving any changes, press the Abort button.

To save any changes and return to the System Settings page, press the Done button.

6.
Reboot the Mio R-4 from the Reboot Page (see the Reboot Page section on page 25).
NOTE: In addition to the Abort button, should you decide not to change the Device Number for any reason, press the Back button
(FIG. 1) to return to the last page displayed.
7.
Select the Back button until you are out of the Setup Menu.
Mio Modero R-4 Remote - Instruction Manual
Green light indicates the overall connection is good.
Shows the number of the connected system.
The IP of the connected master.
The mode used for wireless communication. This is always defaulted to "ZigBee".
The number of the device in the NetLinx system.
The IP for the Gateway providing the connection.
The EUI Address for the Gateway providing the connection.
A ZigBee network ID unique to the device.
The ID for the ZigBee personal area network.
This button opens the Site Survey page (FIG. 19).
This button opens the ZigBee Diagnostics page (FIG. 20).
Protected Settings Menu
23

Advertisement

Table of Contents
loading

Related Manuals for AMX MIO-R4

Related Content for AMX MIO-R4

This manual is also suitable for:

Mio-rcc-kit

Table of Contents