Mio R-4 Setup; Installing Or Replacing The Mio R-4 Lithium-Ion Battery; Battery Low Indicator; Customized Keypads - AMX MIO-R4 Instruction Manual

Mio R-4 Setup

Installing or Replacing the Mio R-4 Lithium-Ion Battery

To install your lithium-ion battery into the Mio R-4:
1. Flip and turn the Mio R-4 so that the buttons are facing away from you and the device is upside down.
2. Holding the device in both hands, place your thumbs on the battery door and slide the battery door free. The battery door
should slide toward the bottom end of the device.
3. Connect the terminal end of the Lithium Ion battery to the port shown in FIG. 2. It may be necessary to use a thin, blunt non-
conductive object to seat the battery connector fully within its port.
Lithium-Ion Battery
Rechargeable
Battery Port
Rechargeable Battery Port on The Mio Remote
FIG. 2
NOTE: Make sure that the battery wires run alongside the battery in the compartment as shown in FIG. 2. Otherwise, the wires
may be damaged or the battery door may not close properly.
4. Place the battery door back on the device, and slide the door upwards to lock it in place.

Battery Low Indicator

When the battery charge level is too low to sustain continuous operation, the Mio R-4's touchscreen will display a popup window
reading "Battery Low" as an initial warning, and then a popup window reading "Battery Very Low" to encourage the user to shut it
down. The device will then shut down to prevent a total discharge of the battery. To recharge the battery, insert the Mio R-4 into the
Mio Remote Charging Base (see Charging The Mio Remote with Charging Base on page 65).

Customized Keypads

The Mio R-4 has the capacity to replace its default English keypad with an optional keypad in one of four languages for Arabic,
French, Italian, or Mandarin Chinese readers. The keypad may also be replaced with other keypads to support other functions or
arrangements of keys. The additional functions or arrangements are supported with firmware upgrades, available for download at
www.amx.com.
NOTE: Each of the alternate keypads requires the appropriate f irmware download for proper function; please refer to the Updating
Firmware section on page 26 for more information.
Mio Modero R-4 Remote - Instruction Manual
Connection
Programming Port
(USB)
Correct path for battery wires and connector
Rear view -
battery compartment
Mio R-4 Setup
11