Saeco Xsmall Plus Service Manual page 33

07 DISASSEMBLY
7.5. Gear motor
1
E
F
B
D
B
Page 4 / 9
Gear motor
1) Loosen the screws holding the boiler pin
in place, remove it and loosen the other
screws shown.
2) The following are located inside the
compartment protected by the casing:
- Electric motor (A) with gears (B) and
(C) for transmission and timing of the
brewing unit.
A
- Dreg drawer present microswitch (D).
- Brewing unit present microswitch (E).
- Microswitch (F) intercepting the brewing
C
unit home and dispensing phases.
- Remove the gear (C) that meshes with
the motor transmission shaft.
- Remove the large gear (B).
2
- Remove the motor (A), complete with
transmission shaft.
3
3) Replace the gear (B), making sure that
the imprint of the arrow is aligned with the
opening containing the pin (P).
P
4) When replacing the motor and the
transmission shaft, make sure the guide
runners (L) are in the right position.
Grease the shaft thoroughly and evenly.
H
L
5
Rev. 00 / Jul. 2008
XSMALL
Saeco Int.