Compass - Cadillac Escalade ESV Owner's Manual

$10araEscalade.fm Page 70 Wednesday, October 14, 2009 9:52 AM
Instrumentation and Controls
EXITING PROGRAMMING
MODE
To exit programming mode, do
any of the following:
• Turn off the ignition.
• Press the driver information
center trip/fuel information
button or vehicle information
button.
• Press the customization
button repeatedly until the
following message appears on
the display:
- PRESS TO EXIT FEATURE
SETTINGS (press to exit
feature settings)
- Press the button to exit the
menu.
• Do not press any buttons.
The display will time out after
40 seconds of inactivity.
. . . 70
Compass (If equipped)
With the ignition on, the compass
reading will appear in the driver
information center display when-
ever the trip/fuel information
menu is active.
As you are driving, N (North), NE
(North East), E (East), SE (South
East), S (South), SW (South West),
W (West) or NW (North West)
should appear on the display to
show your vehicle's direction.
If, after a few seconds, the reading
does not appear, the compass may
need calibration.
There may be a strong magnetic
field (from various magnetic
objects on the vehicle) interfering
with the compass.
Turn off the engine, move the
magnetic objects, then restart the
engine and calibrate the compass.
If CAL appears in the Driver
Information Center display, the
compass needs calibration.
See "Compass Calibration" later in
this section for more information.
It may be necessary to adjust the
compass to compensate for
compass variance.
If an incorrect reading is displayed,
first check that the compass is set
to the correct variance zone. If it is,
the compass may need calibration.
See "Compass Variance" later in
this section for more information.