Si-tex SNS-1100 User Manual page 94

Removing the MEDIA
To remove the MEDIA open the door, then remove the MEDIA from the slot.
CHART PLOTTER DIMENSIONS
INSTALLATION AND REMOVING
It is possible to install this SI-Tex instrument in "Flush Deck" mode, with space saving regard to
the instrument panel plan. To make the "Flush Deck" installation it is necessary to permanently
remove the silicon gasket between rear and front, placed around the chart plotter. To remove the
gasket, lay the chart plotter on its front side, to pay attention do not damage LCD and keyboard,
and use a sharpening blade. Put the blade between the gasket and the lateral side of the rear,
to turn the chart plotter.
Warning
Do not pull the gasket during cut operation, to avoid compromising the chart plotter watertight
seal.
94 - User Manual