Goto Function - Si-tex SNS-1100 User Manual

2.3 GOTO FUNCTION

This functions allows you to place the destination point and immediately start navigating to it.
Navigation to Waypoint
Place the cursor on the desired Waypoint + [ENTER] + "Go To" + [ENTER]
or simply:
Place the cursor on the desired Waypoint + [Go To]
SNS 1100:
Place the cursor on the desired Waypoint + [GOTO]
A circle surrounds the Waypoint symbol. A dotted line is shown, connecting the destination with
the ship's position. When the destination is placed, all navigation data are referred to it.
Deleting destination
If the destination has been placed, to stop the navigation to the Waypoint:
Place the cursor on destination icon + [Stop]
NOTE If you press [Next]/[Prev.] the destination icon is moved on the next/previous Waypoint
in the Route.
Otherwise when the cursor is placed on a generic position on the chart:
[ENTER] + "GOTO" + [ENTER] + [Stop]
NOTE If you press [Start], the destination icon is moved on the new cursor position.
The symbol that identifies the destination disappears from the screen, but the Waypoint
remains.
2.4 USING TRACK
A very useful feature of the chart plotter, is the ability to store and display exactly where the
boat has been. This feature, referred to as Tracking, can provide invaluable information about
the effect of tide and wind influence on the boat's progress as well as giving an indication of the
helmsman's performance.
When full storing capacity has been reached, the oldest points are deleted and overwritten by
the newest ones.
Setting up a Track Step
Before you use the Track function, it is important to specify the Track step unit: if you select
Distance, the Track point is placed when the distance from its last stored position is greater than
the defined distance; if Time, the Track point is placed after the defined time.
[MENU] + "Track" + [ENTER] + "Config" + [ENTER] + "Step Unit" + [ENTER]
You can select the Track step Time [1, 5, 10, 30 sec, 1 min] or distance [0.01, 0.05, 0.1, 0.5, 1.0,
2.0, 5.0, 10.0] Nm. Setting a short time/distance interval between Track points is best suited to
navigate within a close or complex environment, a greater time/distance interval is best suited
to a long voyage.
To select the interval at which the Track points are placed.
If you have selected Distance:
[MENU] + "Track" + [ENTER] + "Config" + [ENTER] + "Distance Step" + [ENTER]
If you have selected Time:
[MENU] + "Track" + [ENTER] + "Config" + [ENTER] + "Time Step" + [ENTER]
Selecting Track Color
User Manual - 29