1.2 SWITCHING ON/OFF
Before powering On the chart plotter, check for the correct voltage (10-35 volt dc) and the
correct connections with the positioning instrument.
Switching On
[POWER] for 1 second
In the opening page, underneath the Techmarine logo, you will find the software version and
type. The next page is the First Setup page (see Par. 1.3) which is activated only when the
chart plotter is turned on for the first time and after a Master reset. Then the chart plotter will
automatically show the Jeppesen warning page and the GPS Status page. Pressing [CLEAR]
at this stage to activate the cartography page.
Switching Off
[POWER] for 3 seconds
A countdown timer appears on the screen, if you release the key before the countdown timer
reaches zero, the chart plotter will remain On.
1.3 FIRST SETUP PAGE
This menu allows you to configure the chart plotter and the external devices the first time the
chart plotter is powered On.
This information can be changed at any time either from the General Options menu (see Par.
3.1) or by resetting the chart plotter. Select the correct setup option and press [ENTER], when
complete press [OK]1 to exit.
14
- User Manual