Changing Backlight And Contrast; Selecting The Language; Selecting The Chart Language - Si-tex SNS-1100 User Manual

1.4 CHANGING BACKLIGHT AND CONTRAST
You can modify the intensity of the backlight and contrast to make reading easy and comfortable.
Press and immediately release [POWER] (do not press and hold the key, or the "power-off"
message will be displayed!). Two sliders appear on the screen, showing the current settings for
backlight and contrast.
[POWER] + use [Bright-]/[Bright+] to adjust backlight levels and/or use [Contr-]/[Contr+]
to adjust contrast levels + [ENTER]
Now you return to the chart screen with the new backlight and contrast levels retained.
1.5 SELECTING THE LANGUAGE
It is possible to set the language to display menus, data pages, warning/alarm messages, full/
quick info, list of objects found by find/nearest function, and on charts (such as place's names,
buoy's names and so on).
To select the language you want:
[MENU] + "General Options" + [ENTER'] + "Language" + [ENTER] + select the language you
want + [ENTER]
NOTE If the selected language is not available on cartographic data, English language is used
instead.
CAUTION
If you have accidentaly selected an unknown language, and you are not able to select
your preferred language please see Chapter 7 "Maintenance" for a RAM Clear operation:
the chart plotter will also return all selections, in particular language, to original default
values. RAM Clear operation will also cancel all the saved data like ROUTE, WAYPOINTS,
MARKS, etc.
1.6 SELECTING THE CHART LANGUAGE
[MENU] + "General Options" + [ENTER'] + "Chart Language" + [ENTER] + select the
language you want + [ENTER]
The possible choices are listed in the table below:
Language: Allows setting the language to display chart information. The language
is chosen among the list of languages available on the cartographic data
(DATA MEDIA or embedded charts).
Mode: Defines how objects are translated. It is possible to choose between the
three following options:
• Off
Uses the same Language used for LANGUAGE. If the selected language is
not present on the objects information, English is used instead;
• English
Always uses English;
• Local
Uses the first Local language present on data. If no Local language is
available, English is used instead.
16 - User Manual