Generic XOR User Manual page 8

J
*
Light Switches
m
When the switch is turned to this position, headlight, rear light, instrument panel light, and
position light will go on.
W
When the switch is turned to this position, rear light, instrument panel light, and position light
w illgo o n.
When the switch is turned to this position, all lights will go off. (Depending on Models)
o Electrical starter Button
This is the electrical starter button. lt is used for startinc the enaine.
When the ignition switch key turns to "ON" and brake lever hold, and then press this
button down to start engine. This mechanism is designed for safety, Thus, the front or
rear brake lever must be hold before usinq this button so that enqine can be started.
CAUTION:
a Release this button immediately after engine has been started. Never press the button again
during the engine is running. This could lead to seriously defects on the engine.
a Do not use light system during starting the engine. Turn headlight and turn signal lights to the
"OFF" position when the engine is being started,
o High/Low Beam Switch
This is the high and low beam of headlight switching switch, Press this switch to switch between
hioh and low beams.
l!Dlrnis is for hich beam.
@]rhi= is for loir beam. (Please turn to low beam when riding in city)
o Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to "ON", and slide the turn signal switch to left or right. Then, the turn signal lights
willflash. lf you press the middle of the switch the indicator willturn off.
1*]Right-side turn signal light flashing means you intend to make a right turn.
l{?lleft-siOe turn signal light flashing means you intend to make a left turn,
o Horn Switch
lffilPress this button down when ignition switch is in the "ON" position, the horn willsound.
o
CAUTION;
Do not press this button when you are in the no horn area.
m
t * - -