Steer I Ng Ha Ndl E F Ron T Sh Ock A B Sorbers L Nsp E C Ti O N; C Hecki Ng An D Cha Ngi Ng F Use S - Generic XOR User Manual

o
o
S TEE RING H AN D L E FRO NT S H O CK A BS O RBE RS INS P E CT IO N
t Perform this check with engine shut off and ignition switch key
r em o v e d .
Visual check front shock absorbers for damage,
Operate steering handle up and down, and check front shock
absorbers for noises due to bends.
Check the bolts and nuts of front shock absorbers with
wrenches for tightness,
o Shake steering handle up & down, left
to check if it is loosen, has too much
one side.
o Check steering handle if it is being pulled too tight by the brake
cabl es.
. Take your motorcycle to GENERIC Authorized Dealer for a
chec k or adj ust m e nt i f any ab norma l co ndi ti o n s a r e fo u n d .
Figures on the right are for operation checks only
C HECKIN G AN D CHANG I NG F US E S
Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new or
having the same specifled amperage rating (7A), Using a fuse of more than 7 amperes, a brass or z
iron wre to replace a blown fuse is strictly prohibited to avoid damaging the electrical system and ti
circuit.
a Remove the battery cover screws, and open the battery cover. Fuses are installed in lhe fuse bc
located by the battery
a Fuses must be firmly secured with wire connectors when replacing'
a Use only parts having the specified specification to replace electrical components such as lig
bulbs. Using parts not having the specified specifications for replacement may cause the fuse
blow and over-discharge the battery,
a Avoid spraying water directly on or around fuse box when washing the motorcycle,
o Take your motorcycle to your dealer for an inspection if a fuse is blown by unknown causes.
INSTALLATION
Press in from above
Fuse connectors
o
& right, and front & rear
resistance and pulls to
R EM O V E