Generic XOR User Manual page 16

CAUTION;
Never change the brake fluid by your own Brake fluid
to a bad function of the brake system and could occur
is a dangerous substance. Wrong service
an accident.
Adjust nut
L o ck n u t
l ea ds
a correct clearance allows throttle vale handle to rotate 2-6mm.
o To adjust, first loosen the fixing nut, then turn the adjusting nut
to the proper position and securely tighten the fixing nut'
Check ltems:
1. Check the throttle valve cable to see if it can be moved
smoothly from a closed position to a wide open position'
2. Rotate steering handle from side to side to check if the
throttle valve cable is interfered.
3.Check to see if the throttle valve cable is obstructed by otner
cables preventing it from being operated smoothly'
r This motorcycle is equipped with a maintenance-free type battery'
and add ele-trolyte,
'
Have your motorcycle checked by GENERIC
Dealer should any abnormality is found
Remove the battery terminals
corrosion on them,
so it is unnecessary to check
Authorized Dealer or Franchised
and clean if there are dirt and
Battery removal procedures are as follows:
Turn ignition switch "oFF," and remove negatlve cable screw firstly
and disconnect the negative cable. Then, femove positive cable
screw and Positive cable.
CAUTION:
o clean the battery posts with warm water if the posts are eroded and have some white
powders
o n tn e m .
a lf there is obvious erosion on the terminals, disconnect the cables,
then clean the erosion off
with a steel brush or a piece of sandpaper'
a lnstall batterv cable after cleaning and apply a thin coat of grease on the terminals'
o Install battery in reverse order of removal
{r