Checki Ng T He S Pa Rk P Lu G; Checki Ng Th E Ai R Cle Ane R - Generic XOR User Manual

CHEC KIN G T H E SP ARK P LU G
a Remove the cap of high tension cable. (Use a plug wrench in tool box to remove the spark plug
turning it counterclockwise,)
a Check the electrode if it is dirty or fouled by carbon deposits.
o Remove the carbon deposits on the electrode with steel wire, and clean the spark plug w
gasoline, then, wipe dry with a rag.
o Check the electrode, and adjust its gap to O,6-0.7mm. (Check it with a feeler gauge)
o Hand tight the spark plug as far as it can go and then tighten it another 1/2-3/4 turns with a wrencl
WARNIN G:
The engine is very hot after running, Pay attention not to get burned,
Use only spark plugs suitable for the engine specifications of this motorcycle recommended by tl
manufacturer. (Refer to specifications.)
CH ECKIN G T HE A IR CLE ANE R
DISASSEM B LE PRCE DURE
1. Remove the screw of air cleaner cover.
2, Remove the air cleaner cover and then the.cleaner's element.
3. Clean or replace the element.
(For checking interval please refer to maintenance schedule,)
4, Refer to figures shown on the right for air cleaner element
cleaning steps.
ASSEM BL E PRCE DURT
o
Assemble the air cleaner in reverse order of disassemble.
C AU TION;
o Dust deposit is one of the major causes of reducing outpui
horsepower and increasing fuel consumption.
o Change the air cleaner element more frequently to prolong the
engine's service life if the motorcycle is driven on dusty roads
very often,
o lf air cleaner is installed improperly, dust will be absorbed into
cylinders, which may cause a premature wear and reducing
output power and engine life.
o Be careful not to soak the air cleaner when washinq the
motorcycle. Otherwise, it will cause engine hard to start,
Procedures for cleaninq
cleaner element:
4 _\.
i \ \
-! l" - *-r
ci>
\'ir"'
t
-
\pF.-L
r F
t l
t t
2 . Sq u e e ze 1 . C I e a n
{
3. S oa k in e n g i n e o i l .
4 . Sq u e e z
l 8