Manual Transport - Dixon SPDZTR 42 Operator's Manual

Manual Transport

When pushing or pulling the mower, engage the eZt
(Integrated Zeroturn transaxle) bypass linkages. the
eZt bypass linkages are located on the rear of the
frame, below the rear engine guard.
1. Raise the deck into the highest cutting
position.
2. Pull the eZt bypass linkages up and out of
the keyhole slots. Release the levers with the
head outside the frame and held in the bypass
position.
3. to reengage the eZt's to drive, reverse the
above procedure.
WARNING!
Use extreme caution when loading
the machine into a truck or trailer
using ramps. There is the possibility
of serious injury or death if the
machine falls off the ramps.
load the machine into truck or trailer by driving up
ramps in low gear. DO nOt lIft! the machine is not
intended to be lifted by hand.
OPeRAtIOn
Bypass linkages
1. eZt engaged
2. eZt locked in the bypass
Bypass linkage - left hand side
2
1
8058-150
8058-033
33