Chapter 3 Network Setup; Initial Se-1200 Mu Setup With A Windows Computer - Datavideo SE-1200MU Instruction Manual

Chapter 3 Network Setup

3.1

Initial SE-1200 MU Setup with a Windows Computer

The SE-1200 MU switcher is not supplied with a traditional hardware based control panel. Instead it is
controlled using a software user interface installed on your Windows-based computer. When new from
the factory the unit will initially have a static IP address of 192.168.100.101. The unit can be directly
connected to a Windows-based computer using an RJ-45 ethernet cable. The following set up should allow
you to initially configure the unit before moving it to an existing DHCP / LAN network.
• An RJ-45 ethernet cable.
• Windows 7/8 laptop or PC.
• The Datavideo SE-1200 MU controller
software.
1. First connect the SE-1200 MU and the Windows computer together using an RJ-45 ethernet cable.
2. Turn on the Windows computer and set it to static IP set up within the Windows Network and
Sharing Centre.
In our example the computer is given the following IP settings so that the computer matches the
same IP range as the switcher.
3. Now install the supplied SE-1200 MU controller software to the computer.
Instructions
11