Pride Mobility QUANTUM 600 SPORT HD Owner's Manual page 29

V . C O M F O R T A D J U S T M E N T S
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connector from the power
base.
4. Remove any wire ties securing the controller har-
ness to the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket.
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew in both armrests.
11. Route the controller harness to the back of the
power base and plug in the controller. See figures
12 and 13.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller harness to the armrest with
wire ties. See figure 13.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat or TRU-Balance Power Posi-
tioning System, refer to the supplemental information
provided with your seating system.
Foot Platform Height Adjustment
The foot platform can be easily adjusted to different
heights in 1.27-cm (0.5-in.) increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 20.
2. Raise or lower the foot platform to the desired
height.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot platform bracket. See figure 20.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot platform bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See
figure 20. Each quick release fastener consists of a bolt, a lever and a nut. See figure 21. The lever has a cam on
the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When
the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release fastener is
clamped.
Quantum 600 Sport HD
FOOT
PLATFORM
BRACKET
Figure 20. Foot Platform Adjustment
Figure 21. Quick Release Fastener Operation
www.pridemobility.com
CAM
NUT
BOLT
UNCLAMPED
LEVER (OPEN)
QUICK
RELEASE
FASTENERS
LEVER (FULLY
CLOSED)
CLAMPED
29