Mail - D-Link DCS-960L User Manual

Section 4: Configuration
This section allows you to configure your camera to send snapshots and video clips to an e-mail address. If you are not sure what settings to use,
check with your e-mail provider (e.g., Gmail, Yahoo Mail, etc.). After making any changes, click Save Settings.
SMTP Server Address: Enter the domain name or IP address of your external e-mail server.
SMTP Server Port:
Enter the port number used by your external e-mail server. (The default value
is 25.)
Sender Email Address: Enter the E-mail Address listed as the sender for your notification e-mails.
Receiver Email Address: Enter the E-mail Address that your notification e-mails will be sent to.
User Name: If the SMTP server uses authentication, enter your User Name.
Password: If the SMTP server uses authentication, enter your Password.
Interval: Enter the interval in seconds (30 - 86400).
Use SSL-TLS/STARTTLS:
Select one of these choices if your SMTP server requires SSL-TLS or STARTTLS
authentication. For example, if you want to use Gmail with SSL-TLS for e-mail
notifications, you can follow the steps below:
Step 1 - Enter smtp.gmail.com in SMTP Server Address field.
Step 2 - Change the SMTP Server Port number from 25 to 465.
Step 3 - Enter your Gmail e-mail address in the Sender E-mail Address.
Step 4 - Enter the destination e-mail address in Receiver E-mail Address.
Step 5 - Enter the User Name required to access the SMTP server.
Step 6 - Enter the Password required to access the SMTP server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail.
Note: You can also use STARTTLS, which will use SMTP server port number 587.
If you want to use a Yahoo SMTP server, the SMTP server address will be different
between each registered region, and only SMTP port 465 is supported for SSL-TLS.
Click Save Settings to save your changes.
D-Link DCS-960L User Manual

Mail

35