Boiler - Viessmann VITODENS 200-W Service Instructions Manual

Coding 2

Boiler

Select "Boiler"
Coding
Coding in the factory setting
01:1
04:1
06:...
07:1
NOT USED
08:...
NOT USED
0D:0
0E:0
13:1
14:1
15:1
21:0
23:0
24:0
28:0
2D:0
2E:0
2F:0
30:0
31:...
38:0
54
Single boiler system
Minimum burner pause subject
to the boiler load (specified by
boiler coding card)
Maximum limit of the boiler
water temperature, specified
in °C by the boiler coding card
Boiler number in multi boiler
systems
Maximum burner heating output
in kW in the case of a multi
boiler system
DO NOT ADJUST
DO NOT ADJUST
DO NOT ADJUST
DO NOT ADJUST
DO NOT ADJUST
No service interval (hours run)
selected
No time interval for burner
service
No "Service" display
No burner interval ignition
DO NOT ADJUST
DO NOT ADJUST
Venting program/fill program
disabled
Coding address should be set
to 30:0, if not adjust to 30:0
Set speed in % of the internal
circulation pump when operated
as boiler circuit pump, specified
by the boiler coding card
Status burner control unit:
Operational (no fault)
Vitodens 200-W B2HA 19, 28, 35 Service
Possible change
01:2 Multi boiler system with Vitotronic
300-K.
04:0 Minimum burner pause set
permanently (specified by boiler
coding card).
06:20 Maximum limit of the boiler water
to temperature within the ranges
06:127 specified by the boiler.
07:2 Boiler number 2 to 8 in multi boiler
to systems.
07:8
08:0 Maximum burner heating output
to adjustable from 0 to 199 kW
08:199 (limited by boiler specific
parameters) in steps of 1 kW.
--
--
--
--
--
21:1 Number of hours run before the
to burner should be serviced is
21:100 adjustable from 100 to 10,000 h
One adjusting step ≙ 100 h.
23:1 Interval adjustable from 1 to 24
to months.
23:24
24:1 "Service" display (the address is
automatically set and must be
manually reset after a service has
been carried out).
28:1 Interval adjustable from 1 h
to to 24 h. The burner is force
28:24 started once every 30 sec (only
when operating with LPG).
--
--
2F:1 Venting program enabled.
2F:2 Fill program enabled.
30:3 If the boiler is reset, the coding
address may automatically reset to
30:3. To prevent continuous boiler
pump operation, adjust the coding
address to 30:0.
31:0 Set speed adjustable from
to 0 to 100%.
31:100
38:≠0 Status burner control unit: Fault.
--
--
--
--
--
--
--