Stihl FSA 65 Instruction Manual page 7

Transporting the Unit
Always switch off the power tool, move
the retaining latch to ƒ and remove the
battery – even when you carry the
machine for short distances. This avoids
the risk of the motor starting
unintentionally.
Carry the power tool properly balanced
by the shaft.
Transporting in a vehicle: Properly
secure the power tool to prevent
turnover and damage.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
– The trigger switch and trigger
lockout must move freely (retaining
latch to ‚) – switches must return
to the idle position when they are
released.
– Use only an approved combination
of cutting attachment, deflector and
handle. All parts must be
assembled properly and securely.
To reduce the risk of injury, never
use metal cutting attachments.
FSA 65, FSA 85
– Check that the cutting attachment is
properly and securely mounted and
in good condition.
– Check protective devices (e.g.
deflector for cutting attachment) for
damage or wear. Always replace
damaged parts. Never operate the
unit with a damaged deflector.
– Never attempt to modify the controls
or the safety devices in any way.
– Keep the handles dry and clean –
free from oil and dirt – for safe
control of the power tool.
– Check contacts in battery
compartment for foreign matter.
– Fit the battery correctly – it must
engage audibly.
– Never use defective or deformed
batteries.
To reduce the risk of accidents and
personal injury, do not operate your
power tool if it is not properly assembled
and in good condition.
Before switching on the power tool,
make sure the cutting attachment is not
touching the ground or any other object.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Note that the cutting
attachment continues to
run for a short period
after the power tool is
switched off – flywheel
effect.
Holding and Controlling the Unit
Always hold the unit firmly with both
hands on the handles. Make sure you
always have good balance and secure
footing.
Right-handers
Left hand on the loop handle and right
hand on the control handle.
Left-handers
Right hand on the loop handle and left
hand on the control handle.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery.
English
5