Wiring And Using Terminal Cover; Installation; Note On Installation; Installation 6.1. Note On Installation - Toa F-1000BTWP EB-Q Instruction Manual

5. WIRING AND USING TERMINAL COVER

3
Tapping screw 4 x 12 (accessory)
4
1
Speaker cable
ø 6 ‒ ø 10 mm
Notes
• For the speaker cable, use a cable with a diameter of 6 ‒ 10 mm, which will fit the cable bushing.
• To ensure waterproof capabilities, firmly mount the terminal cover to the speaker and tighten the bushing on
the cover.
Step 1. Feed the speaker cable through the bushing and terminal cover, then connect the cable to the input
terminal.
Step 2. Attach the terminal cover to the speaker.
Attach the cover while pulling the cable so that it is not entangled inside the terminal cover.
Step 3. Hold the terminal cover tightly to the speaker using the supplied screws.
Step 4. Tighten the bushing.
Note
After tightening the bushing by hand, use a tool to further tighten it another 90º (1/4-turn) or so. Note
that parts can be damaged by over-tightening.

6. INSTALLATION

6.1. Note on installation

• Be sure to mount the speaker in a vertical (portrait-style) orientation.
• Adjust the speaker's tilt angle within the shaded range shown below:
[Wall and Ceiling: 0º horizontal to 45º downward]
Note
Mount the speaker so that its rear-mounted
terminal cover is positioned on the upper side.
0º
(horizontal)
Max. 45°
• Use the supplied terminal cover when connecting the speaker cable.
4
2
Terminal cover (accessory)
Bushing*
* Screwed onto the Terminal cover at the factory.
Input terminal
[Stripped conductor]
0°
(horizontal)
45º
[ Imput terminal polarity ]
Input terminal
BLACK
10 mm
30 mm
Speaker unit
Terminal cover
(‒) (+)
RED