Doors - Heat & Glo SL-550BE-B Owner's Manual

D. Doors
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
UNITS AND
SL-550BE-B, SL-550BE-IPI-B (550-Template)
TEMPLATE PART #
FINISH MATERIAL
DOOR FIT
THICKNESS
Aero-32 Inside 4 inches Max.
Chad-32E Overlap 1 inch Max.
Chad-32E Inside 1-4 inches
Halston-32E Overlap 1 inch Max.
Halston-32E Inside 1-4 inches
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop fi nishing material fl ush with fi replace surround opening.
Figure 13.17 Aero Door
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 13.18 Overlap Fit Door (Chad and Halston)
60
SEE
X Y
FIGURE
13.17 N/A N/A
13.18 N/A N/A
13.19 32-3/8 in. 30-3/8 in.
13.18 N/A N/A
13.20 32-3/8 in. 30-3/8 in.
DOOR
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
Heat & Glo • SL-550BE-B, SL-550BE-IPI-B • 2158-900 Rev. H • 8/09
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
(Includes 1/8 in. opening each side of door)
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
Figure 13.19 Inside Fit Door (Chad)
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
(Includes 1/8 in. opening each side of door)
Finishing material between 1 and 4 inches thick.
Refer to Table 1 for X and Y dimensions.
Figure 13.20 Operable Hinge Door (Halston)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
DOOR
Y
X
FINISHING
MATERIAL

DOORS

X
Y