Disassembly - Aiwa HT-DV2300 Service Manual

DISASSEMBLY -1/2

DISASSEMBLY -
QQ
3 7 63 1515 0
CAUTION BEFORE STARTING SERVICING
Electronic parts are susceptible to static electricity and may easily damaged, so do not forget to take a proper ground-
ing treatment as required.
Many screws are used inside the unit. To prevent missing, dropping, etc. of the screws, always use a magnetized screw
driver in servicing. Several kinds of screws are used and some of them need special cautions. That is, take care of the
tapping screws securing molded patrs and fine pitch screws used to secure metal parts. If they are used improperly,
the screw holes will be easily damaged and the parts can not be fixed.
CABINET DISASSEMBLY
1. Top Case
1. Release 7 screws (A). (See Fig. 2-1)
2. Lift the top case with holding the back of it, and
remove it in the direction of the arrow.
Top Case
(A)
TE
L 13942296513
2. Tray Door
1.Eject the disc tray.
2.Lift up the tray door in the direction of the
arrow.
Tray Door
www
.
http://www.xiaoyu163.com
(A)
(A)
(A)
(A)
Fig. 2-1
Disc Tray
x ao
y
Fig. 2-2
i
http://www.xiaoyu163.com
8
3. Front Panel
1. Eject the disc tray. (See Fig. 2-2)
2. Remove the tray door. (See Fig. 2-2)
3. Pull the front panel toward you while pressing 5
stoppers to disengage, and remove the front panel.
(See Fig. 2-3)
Front Cable
(A)
(A)
Stopper
Q Q
3 6 7 1 3
u163
.
-6-
2 9 9 4 2 8
Stopper
Front Panel
1 5 0 5 8 2 9 9 4
Fig. 2-3
m
co
9 9
2 8 9 9