Paper Ironer - IBM 6400 series Maintenance Manual

Paper Ironer

CAUTION:
<2> Over time the upper edge of the paper ironer can become sharp. To
avoid cutting yourself handle the paper ironer on the sides.
Removal
1. Remove the shuttle frame assembly (page 249).
2. Move the forms thickness lever to the open position.
3. Push the ends of the paper ironer toward the rear of the printer,
disengage the tabs, then lift it up and out (page 283, Figure 49).
Installation
NOTE: The black tape on the paper ironer faces the paper detector switch
1. Position the paper ironer so that the black tape is on the side that faces
the paper detector switch assembly. (See page 283, Figure 49.)
2. Push the paper ironer down into the slots until the tabs engage.
3. Install the shuttle frame assembly (page 249).
4. Return the printer to normal operation (page 159).
236
assembly.
Replacement Procedures and Illustrated Parts List