Integra DTR-20.7 Basic Manual page 64

Setting Item Default Value
Back Right 7�0ft/2�10m
Back Left 7�0ft/2�10m
Surround Left 7�0ft/2�10m
Subwoofer 12�0ft/3�60m
● Default values vary depending on the regions�
● The speaker "Distance" may be unable to be changed depending on the settings in "Configuration" -
"Speaker Channels" / "Subwoofer"�
Level Calibration
Adjust the level of each speaker with the built-in test tone� Settings are automatically
configured if you use the Automatic Speaker Setup�
Setting Item Default Value
Front Left 0 dB
Center 0 dB
Front Right 0 dB
Height Left 0 dB
En-32
Setting Details
Specify the distance between each speaker and
the listening position�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Specify the distance between each speaker and
the listening position�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Specify the distance between each speaker and
the listening position�
Specify the distance between each speaker and
the listening position�
Setting Details
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Setting Item Default Value
Height Right 0 dB
Surround Right 0 dB
Back Right 0 dB
Back Left 0 dB
Surround Left 0 dB
Subwoofer 0 dB
● The speaker "Level Calibration" may be unable to be changed depending on the settings in
"Configuration" - "Speaker Channels" / "Subwoofer"�
● "Level Calibration" cannot be changed while muting is on�
Advanced Settings (Setup Menu)
Setting Details
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
● This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Select a value between "-12 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�
Select a value between "-15 dB" and "+12 dB"�
A test tone will be output each time you change
the value� Select the desired level�