Delta UNISAW 36-L31 Instruction Manual page 15

2. Place the motor cover (A) in the opening of the
Unisaw as shown in Fig. 34. Place the rear motor cover
clips inside the motor opening and push the front of the
motor cover until all four motor cover clips are engaged
with the motor cover opening in the Unisaw.
3. Align the hole (B) Fig. 35 in the bottom of the motor
cover with the hole in the side of the saw cabinet. Place
a 1/4" flat washer on a 1/4-20x5/8" hex head screw.
Insert screw through hole in motor cover and thread
screw into hole in side of motor cabinet and tighten
securely.
4. Fig. 35 shows the motor cover attached to the
Unisaw.
NOTE: TO REMOVE THE MOTOR COVER, REMOVE
THE 1/4-20x5/8" HEX HEAD SCREW (B) FIG. 35, AND
PUSH MOTOR COVER TO ONE SIDE TO DEPRESS
CLIPS, AND PULL MOTOR COVER OFF.
RIP FENCE HOLDER BRACKETS
Assemble the rip fence holder brackets (A) and (B) Fig.
36, to the four holes located in the right hand side of the
saw cabinet using four #10 x 1/2" sheet metal screws
supplied.
DUST CHUTE ADAPTER
The Unisaw is supplied with a dust chute connector to
provide a means of connecting a 4" diameter dust
collector hose to the machine. Align the four holes in the
dust chute adapter (A) Fig. 37,with the four holes in the
back of the saw cabinet (B) and attach the dust chute
adapter with four #10 x 1/2" sheet metal screws.
DO NOT MOUNT THE DUST CHUTE
ADAPTER
COLLECTION SYSTEM IS USED IN CONJUNCTION
WITH THE SAW, FOR THE DUST CHUTE ADAPTER
WILL RESTRICT THE GRAVITY FEED OPENING FOR
SAW DUST REMOVAL.
MITER GAGE AND WRENCH STORAGE
The miter gage and arbor wrenches can be stored in the
slots provided in the motor cover, as shown in Fig. 37A.
Fig. 37A
UNLESS A DUST
B
A
A
B
15
Fig. 34
Fig. 35
B
Fig. 36
Fig. 37