Table of Contents
Advertisement
Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Base no power
or
No link.
Reconnect AC
adaptor.
Check Phone Line
*1
Error
Failed
Incomplete
Memory Full
Use rechargeable
battery.
You must first
subscribe to
Caller ID.
*1 KX-TG5522/KX-TG5523
38
Cause/solution
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been cancelled.
Re-register the handset (page 25).
L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 8).
L Recording was too short. Try again.
L Phonebook copy failed (page 17). Confirm the other
handset (the receiver) is in standby mode and try
again.
L The receiver's phonebook memory is full. Erase the
unwanted phonebook entries from the other handset
(the receiver) and try again.
L The phonebook memory is full. Erase unwanted
entries (page 16).
L Message memory is full. Erase unwanted messages
*1
(page 29, 30).
L The call barred list memory is full. Erase unwanted
entries (page 24).
L A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 6.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
*1
Advertisement
Table of Contents
