Positioning Stones - Heat & Glo Soho24B Owner's Manual

D. Positioning Stones
For proper performance and safety, it is critical that the Black
Onyx stones are set up in accordance with these instructions.
WARNING! Choking Hazard! Keep stones out of reach
of children.
BURNER AREA
Figure 12.1.
As you are positioning the stones, make sure that no
stones are in the cross-hatched area shown between the
two arrows above. This is to ensure proper lighting and
avoid interference with the pilot fl ame.
WARNING
Delayed Ignition Risk
• Place stones according to instructions.
• Do NOT place stones in area in front of pilot
shield.
• Do NOT place stones in a position that they may
fall into area in front of pilot shield.
• Do NOT use any media other than the stones
supplied with this fi replace.
Fireplace will not function properly.
Delayed ignition may occur.
JIG
Figure 2.
Step 1. The included stone placement jig MUST be used
any time stones are placed on the burner to ensure that
none end up in the cross-hatched area noted in Figure 1.
Figure 12.3.
Step 2. The stone placement jig is shipped in its proper
position. Remove the two screws securing the jig, making
sure the jig stays in the proper position. See Figure 3.
Step 3. Place a single layer of stones over the burner area
inside of the tabs surrounding the burner and behind the
pilot shield.
PILOT SHIELD
Figure 12.5.
Step 4. Place the remaining stones over the basepan
taking care not to add more stones to the burner area.
Heat & Glo • Soho24B • 2137-900 Rev. P • 8/12
Stone Placement: Soho24B
Figure 12.4.
2137-936C
35