Step 13 Lighting The Appliance; After The Installation; Section 4: Maintaining And Servicing Your Appliance; Changing Light Bulbs - Heat & Glo Passage Owner's Manual

Step 13. Lighting the Appliance
You've reviewed all safety warnings, you've checked the
appliance for gas leaks, you know the vent system is
unobstructed, and you've checked for faulty components.
Now you're ready to light the appliance.
WARNING: PLEASE REFER TO THE USER'S
!
MANUAL FOR ALL CAUTIONS, SAFETY, AND
WARNING INFORMATION PERTAINING TO THE
LIGHTING AND OPERATION OF THE APPLIANCE.
4
Maintaining and Servicing Your Appliance
Appliance Maintenance
Although the frequency of your appliance servicing and main-
tenance will depend on use and the type of installation, you
should have a qualified service technician perform an appli-
ance check-up at the beginning of each heating season.
See the table below for specific guidelines regarding each
appliance maintenance task.
IMPORTANT: TURN OFF THE GAS BEFORE SERVICING
YOUR APPLIANCE.
Cleaning Burner and Controls
Frequency: Once annually.
By: Qualified service technician.
Task: Brush or vacuum the control compartment, appliance
logs and burners inside the logs.
Cleaning Flame Sensor Rod (IPI Systems)
Frequency: Periodically.
By: Qualified service technician.
Task: Make a visual check of the straight flame sensor rod
(see Figure 22). Use emery cloth to carefully remove any
existing white film or deposits.
Checking Flame Patterns, Flame Height
Frequency: Periodically.
By: Qualified service technician/Home owner.
Task: Make a visual check of your appliance's flame
patterns. Make sure the flames are steady - not lifting or
floating.
Checking Vent System
Frequency: Before initial use and at least annually
thereafter, more frequently if possible.

After the Installation

By: Qualified service technician/Home owner.
Task: Inspect the external vent cap on a regular basis to
ensure that no debris is interfering with the flow of air. Inspect
entire vent system for proper function.
Cleaning Glass Door
Frequency: After the first 3 to 4 hours of use. As neces-
sary after initial cleaning.
By: Home owner.
Task: Remove and clean glass after the first 3 to 4 hours of
use. After the initial cleaning, clean as necessary. Film
deposits on the inside of the glass door should be cleaned
off using a household glass cleaner. NOTE: DO NOT handle
or attempt to clean the door when it is hot and DO
NOT use abrasive cleaners.
Recommended Bulbs
Frequency: Periodically. Sylvania mini Candelabra 75W
Halogen bulbs are recommended for use in the appliance.
By: Home owner
Task: To replace light bulb
1. Turn off appliance and electric embers and allow to cool
2. Remove the screws holding the panel in place and pull
3. Replace bulb. See installation instructions on bulb pack-
4. Replace bulb housing making sure to not touch the bulb
5. Tighten the screws to anchor the panel in place.
Heat & Glo • Passage • 700-900 Rev. M • 12/07
LEAVE THIS INSTALLATION MANUAL WITH
!
THE APPLIANCE FOR FUTURE REFERENCE.
(min. 6 hrs.).
out bulb housing.
aging for details on changing the halogen bulb.
or have the bulb touch the firebox.
29