Toshiba Qosmio F60 Series Maintenance Manual page 329

エラー スタイルが定義されていません。 エラー
!
エラー
Installing the optical disk drive
To install the Optical disk drive, follow the steps below and refer to Figure 4-14 to 4-16.
1. When installing a new optical disk drive, set the ODD bezel to the optical disk drive
while securing the latches.
Optical disk drive
2. Set the ODD rear bracket to the optical disk drive and secure them with the
following screws.
 M2.02.7C
3. Set the ODD side bracket to the optical disk drive and secure them with the
following screw.
 M2.03C
4. Insert the optical disk drive assembly into the slot of the base assembly.
CAUTION: When the optical disk inside the optical disk drive can not be ejected because
of some failure, open the disc tray by inserting a slender object (about 15
mm) such as a straightened paper clip into the eject hole near the eject
button.
QOSMIO F60 Maintenance Manual (960-796)
スタイルが定義されていません。
!
Figure 4-16 installing the ODD bezel
Unique screw
S-THIN HEAD screw
スタイルが定義されていません。
!
Replacement Procedures
Latch
2
1
[CONFIDENTIAL]
エラー
ODD bezel
4-31
ス
!