Booting In Continuous Loop - HP f10 Troubleshooting Manual

Booting in Continuous Loop

Booting in Continuous
Using t5000 F10 Setup, change boot
priority to factory defaults.
1. USB Device
2. Flash*
3. Network
*Check "Amount of Flash memory" in
system information table.
Reboot the thin client
If you are using XPe OS, disable the
write filter. Chek that Altiris 5.6
Deployment server is being used.
Reboot the thin client
Reimage the system.
46 Chapter 4 Diagnostics and Troubleshooting
Loop
Yes
Boot
Yes
OK?
No
Yes
Boot
OK?
No
Done
Yes
Boot
OK?
Reboot the thin client
t5000 Troubleshooting Flow Chart
End
Service the unit.
Note: Refer to the
Warranty for coverage
information.
No