Table of Contents
Advertisement
Fan
Fan
Removing the
To remove the fan, refer to Figure 5–12 and proceed as follows:
Fan
1. Prepare the system for service according to Preparing for
2. Remove the front bezel, top and front covers according to
3. Disconnect the fan power cable
4. Remove four sets of hardware fastening the fan to the
5. Remove the fan out through the front of the chassis.
Installing the
Fan
5–26 Removal and Installation Procedures
Service .
Removing the Covers .
When working near or handling the fan, beware of
the sharp edges and points of the fan blades.
chassis. Two sets each include a long screw
, and kepnut
. They fasten the fan
and do not secure the finger guards. The remaining two sets
of hardware include only a long screw and kepnut. They
fasten the two finger guards
chassis.
When installing the fan, ensure that the airflow
direction indicator (arrow) on the bottom of the
fan points towards the rear of the chassis.
Make sure the finger guards are installed so they
do not touch the fan hub and blades.
.
Warning
, flat washer
to the chassis
along with the fan to the
Caution
Advertisement
Table of Contents
