Installing the System on Slides
Installing the System on Slides
The rackmount server is shipped with one pair of slide
assemblies (P/N 12-32764-05), which include:
•
•
•
•
Installing the system on slides, involves:
1. Preparing the Slides.
2. Attaching the Slide Races.
3. Attaching Slides to Rails.
4. Mounting System on Slides.
Tools Required
You need a flat blade screwdriver to install the rackmount server.
Preparing the
Refer to Figure 3–1 and prepare the slides as follows:
Slides
1. Find the slide assembly
2. Pull out the inside race
3–2 Installing the Rackmount Server
Two rear brackets.
Two front brackets.
Pair of slide assemblies.
Attaching hardware.
To avoid damaging the slides, it is important that
the installation is performed as instructed in the
following procedure.
the system. (If the slide assemblies are not labeled, pull out
the inside race
until the arrow
are visible (do not remove the inside race). The RH slide is
the one with the locking lever
arrow
next to it pointing upward as shown in Figure 3–1.
Mark the slide RH.)
race from the slide at this time.
Caution
labeled RH that is shipped with
and locking lever
pointing to the left and the
until in locks. Do not remove the